Drop-In decoder install fee
This fee is to be added if you would like any drop-in decoder installed in a compatible locomotive purchased on the same order at Fifer Hobby
Part # install
$25.00 each (loco decoder set)
Click to order
Broadway Limited Address Changer
This device can be used with any dcc system to reset , address and consist locomotives.
http://youtu.be/sUUqtRPzjLc
Part # BLI-1020
$71.99
Click to order
Broadway Limited CV Setter
This device can be used with any dcc system to set CV’s on decoders.
https://www.youtube.com/watch?v=WxAP59OpfkM
Part # BLI-1148
$63.99
Click to order
Accu-Lites BDL168 Breakout Board
The single input breakout board for the BDL168 block detection eliminates soldering connections to the card edge or card edge adapter of this product.
This design has a single input, meaning all 4 detection zones (and all 16 sections) are connected to a single booster, command station or DCC circuit breaker.
Part # ACCU-4002
$28.99
Click to order
Accu-Lites SE8C Breakout Board
The SE8c breakout board brings out all the connections available on the SE8c’s edge connector.
This includes the 8 slow motion switch machine drivers, the 8 pushbutton inputs and the 8 sensor connections as well.
Part # ACCU-4005
$29.99
Click to order
TCS Kapton Tape 1/2 inch
1/2″ wide x 36 yd. roll of Kapton tape.
Kapton tape is a very high temp. resistant insulating tape for use in tight areas for positive insulating of metal to metal surfaces.
Part # TCS-KT2-1304
$14.29
Click to order
1/4″ wide x 36 yd. roll of Kapton tape.
Kapton tape is a very high temp. resistant insulating tape for use in tight areas for positive insulating of metal to metal surfaces.
Part # TCS-KT2-1256
$15.19
Click to order
New design , fits most DCC throttles.
Part # NRM-40020
$10.19
Click to order
New design , fits most DCC throttles. (3 pack)
Part # NRM-40020-3
$25.49
Click to order
New design , fits most DCC throttles. (10 pack)
Part # NRM-40020-10
$63.99
Click to order